( I only used 4 bolts to torque the crank in. You need to put one peice on each bearing and then install the crank and the girdle. Here is the plasti-gauge on the crank bearing. Torque should always be done to manufactures specs.) The oil squirters have also been installed. (I got 3 main studs that were wrong so those are not pictured. The block was bored and honed at the machine shop and hot tanked and is pictured with 1/2 of the crank bearings in and the main studs. Cleanliness is very important since any debris can cause problems at start up. It is to be used in conjunction with a Factory Service Manual to guide you through your building experience.įirst Make sure you have a nice clean area to work in. This pictorial guide will help you to assemble a KA24DE motor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |